## Integer Constants

Integer constants are numbers used directly in a sketch, like `123`

. By default, these numbers are treated as int‘s but you can change this with the U and L modifiers (see below).

Normally, integer constants are treated as base 10 (decimal) integers, but special notation (formatters) may be used to enter numbers in other bases.

Base Example Formatter Comment 10 (decimal) 123 none 2 (binary) B1111011 leading 'B' only works with 8 bit values (0 to 255) characters 0-1 valid 8 (octal) 0173 leading "0" characters 0-7 valid 16 (hexadecimal) 0x7B leading "0x" characters 0-9, A-F, a-f valid

**Decimal** is base 10. This is the common-sense math with which you are acquainted. Constants without other prefixes are assumed to be in decimal format.

Example:

101 // same as 101 decimal ((1 * 10^2) + (0 * 10^1) + 1)

**Binary** is base two. Only characters 0 and 1 are valid.

Example:

B101 // same as 5 decimal ((1 * 2^2) + (0 * 2^1) + 1)

The binary formatter only works on bytes (8 bits) between 0 (B0) and 255 (B11111111). If it is convenient to input an int (16 bits) in binary form you can do it a two-step procedure such as:

myInt = (B11001100 * 256) + B10101010; // B11001100 is the high byte

**Octal** is base eight. Only characters 0 through 7 are valid. Octal values are indicated by the prefix “0”

Example:

0101 // same as 65 decimal ((1 * 8^2) + (0 * 8^1) + 1)

**Hexadecimal (or hex)** is base sixteen. Valid characters are 0 through 9 and letters A through F; A has the value 10, B is 11, up to F, which is 15. Hex values are indicated by the prefix “0x”. Note that A-F may be typed in upper or lower case (a-f).

Example:

0x101 // same as 257 decimal ((1 * 16^2) + (0 * 16^1) + 1)

#### U & L formatters

By default, an integer constant is treated as an int with the attendant limitations in values. To specify an integer constant with another data type, follow it with:

- a ‘u’ or ‘U’ to force the constant into an unsigned data format. Example:
`33u`

- a ‘l’ or ‘L’ to force the constant into a long data format. Example:
`100000L`

- a ‘ul’ or ‘UL’ to force the constant into an unsigned long constant. Example:
`32767ul`

#### See also