/*
  Grove-Temperature-Humidity Sensor

* Note: Put your hands on Grove-Temperature-Humidity Sensor, both of the value
         will rise.

 This example code is in the public domain.
 */

#include "TM1637.h"
#include "DHT.h"

/* Macro Define */
#define CLK               9                  /* 4-digital display clock pin */
#define DIO               10                 /* 4-digiral display data pin */
#define BLINK_LED         RED_LED            /* blink led */
#define TEMP_HUMI_PIN     A1                 /* pin of temperature&humidity sensor */

/* Global Varibles */
TM1637 tm1637(CLK, DIO);                  /* 4-digital display object */
DHT dht(TEMP_HUMI_PIN, DHT22);            /* temperature&humidity sensor object */

int8_t t_bits[2] = {0};                   /* array to store the single bits of the temperature */
int8_t h_bits[2] = {0};                   /* array to store the single bits of the humidity */

/* the setup() method runs once, when the sketch starts */
void setup() {
    tm1637.init();                       /* initialize 4-digital display */
    tm1637.set(BRIGHT_TYPICAL);          /* set the brightness */
    tm1637.point(POINT_ON);              /* light the clock point ":" */
    dht.begin();                         /* initialize temperature humidity sensor */
    pinMode(RED_LED, OUTPUT);            /* declare the red_led pin as an OUTPUT */

}

/* the loop() method runs over and over again */
void loop() {

    int _temperature = dht.readTemperature();             /* read the temperature value from the sensor */
    int _humidity = dht.readHumidity();                   /* read the humidity value from the sensor */

    memset(t_bits, 0, 2);                                 /* reset array when we use it */
    memset(h_bits, 0, 2);

    /* 4-digital-display [0,1] is used to display temperature */
    t_bits[0] = _temperature % 10;
    _temperature /= 10;
    t_bits[1] = _temperature % 10;

    /* 4-digital-display [2,3] is used to display humidity */
    h_bits[0] = _humidity % 10;
    _humidity /= 10;
    h_bits[1] = _humidity % 10;

    /* show it */
    tm1637.display(1, t_bits[0]);
    tm1637.display(0, t_bits[1]);

    tm1637.display(3, h_bits[0]);
    tm1637.display(2, h_bits[1]);
}